XD5120
INSTALLATION/OWNER'SꢀMANUAL
AM/FM/CDꢀReceiver
XD5120ꢀINSTALLATION
Installation
TYPICALꢀMOUNTINGꢀMETHOD
3
XD5120ꢀINSTALLATION
Wiring
Diagram
FUSES
When replacing fuses,
make sure new fuse is the
correct type and amperage.
Using an incorrect fuse
could damage the radio.
The XD5120 uses one 7
amp AGC fuse (Battery),
one 0.5 amp AGC fuse
(Ignition) and one 0.5 amp
AGC fuse (Remote Turn-on)
located in-line.
* Caution - Do not attach any speaker leads to ground as severe damage will occur.
4
XD5120ꢀOPERATION
ControlꢀLocations
1
2
3
4
5
6
16
13
12
11
10
9
8
7
17
15
14
1
2
3
4
5
6
7
10
11
12
13
14
15
Release
Power
Band
Play/Pause
Loudness/CD Random
Local/Distance/CD Repeat
Audio
Mono/Stereo/CD Intro
Volume Up
Eject
Mute
EQ
Volume Down
Track Up
Display
Tuning
16
17
8
9
Track Down
5
XD5120ꢀOPERATION
GeneralꢀOperation
FaceplateꢀRemoval
Press RELEASE and pull away from the left side to
remove. To re-install, insert right side of faceplate first
then push left side to secure.
PowerꢀOn/Off
Press POWER to turn the unit on. Inserting a CD will
turn the unit on automatically. Press POWER to turn the
unit off.
CDꢀMode
Insert a CD or press
playback.
/
II to begin or resume
l
TunerꢀMode
Press POWER or BAND to begin or resume tuner
operation.
ꢀ
Loudness
Press LOUD to activate and deactivate bass boost
curve. Activating this feature will enhance the bass
frequencies when listening to music at all volumes.
Volume
Mute
Adjust volume using VOL + or VOLꢀ-ꢀ(0-63).
Press MUTE to silence the audio.
Press MUTE again to cancel.
Display
Press DISP to display the clock. The radio frequency
(tuner mode) or CD elapsed time/track (CD player
mode) show by default.
6
XD5120ꢀOPERATION
GeneralꢀOperation
SetꢀtheꢀClock
PresetꢀEQꢀCurves
Audio
Press and hold DISP until the clock begins to flash,
then release. Press TRACKꢀꢀꢀꢀꢀꢀꢀꢀ to adjust the hours
and TRACKꢀꢀꢀꢀꢀꢀꢀ to adjust the minutes. Press DISP
momentarily to save the selected time.
Press EQꢀto select between POP, CLASSIC, ROCK
and OFF (default) equalization curves. The Bass and
Treble settings are not adjustable when an EQ curve
is selected.
Press AUD to select between Volume (default), Bass,
Treble, Balance & Fader.
VOLUME
BASS TREBLE
BALANCE
FADER
ꢀ
Bass
Press AUD until BAS appears
Press VOLꢀ- or + to adjust
(-7 minimum / 7 maximum)
Treble
Balance
Fader
Press AUD until TRE appears
Press VOLꢀ- or + to adjust
(-7 minimum / 7 maximum)
Press AUDꢀuntil BAL appears
Press VOLꢀ-ꢀ(LEFT)ꢀor + (RIGHT) to adjust
(BA.L 10/BA.R 10) BAL 0 represents equal balance.
Press AUD until FAD appears
Press VOLꢀ- (FRONT)ꢀor +ꢀ(REAR)ꢀto adjust
(FA.F 10/FA.R 10) FAD 0 represents equal fader.
7
XD5120ꢀOPERATION
TunerꢀOperation
Tuning
Turn TUNE knob to select desired station.
FMꢀMono/Stereo
Press MONO during FM tuner operation to select mono
or stereo (default) reception of the broadcast signal.
Local/Distance
Press LOC during FM tuner operation to activate local
tuning for strong station reception only. Press LOC
again to cancel and resume Distance tuning (default).
Bandꢀ Press BAND to select between FM and AM bands.
8
XD5120ꢀOPERATION
CDꢀPlayerꢀOperation
InsertꢀCD
EjectꢀCD
With the label facing up, insert a disc into the CD slot.
The CD will automatically begin playback.
Press the EJECT button to stop and eject the CD.
The unit will change to tuner mode. If the disc is not
removed within 10 seconds, the unit will reload the
disc.
TrackꢀSelect
Press TRACK
track. Press TRACK
to skip to the beginning of the next
to return to the beginning of
the current track. Pressing TRACK
again skips to
the beginning of the previous track.
FastꢀForwardꢀ Press and hold TRACK
or TRACK
to fast
andꢀReverse
forward or reverse a track.
Pause
Press
Press
/
/
II to temporarily stop CD playback.
l
l
II again to resume playback.
Intro
Repeat
Press INT to play the first 10 seconds of each track.
Press INT to cancel.
Press RPT to continuously repeat selected track.
Press RPT to cancel.
Random
Press RDM for more than 2 seconds to play all tracks
in random order. Press RDM again for more than 2
seconds to cancel.
CD-R/CD-RWꢀ Some CD-Rs and CD-RWs may be incompatible with
Compatibility
this unit, depending on media type and recording
method.
9
XD5120ꢀWARRANTY
LimitedꢀOneꢀYearꢀWarranty
This warranty gives you specific legal rights.
You may also have other rights which vary from
state to state.
What to do?
1. Before you call for service, check the
troubleshooting guide in your owner’s
manual. A slight adjustment of any custom
controls may save you a service call.
Dual Electronics Corp. warrants this product to
the original purchaser to be free from defects in
material and workmanship for a period of one
year from the date of the original purchase.
2. If you require service during the warranty
period, you must carefully pack the product
(preferably in the original package) and ship
it by prepaid transportation with a copy of the
original receipt from the retailer to an
authorized service center.
Dual Electronics Corp. agrees, at our option,
during the warranty period, to repair any defect
in material or workmanship or to furnish an
equal new, renewed or comparable product
(whichever is deemed necessary) in exchange
without charges, subject to verification of the
defect or malfunction and proof of the date of
purchase. Subsequent replacement products
are warranted for the balance of the original
warranty period.
3. Please describe your problem in writing and
include your name, a return UPS shipping
address (P.O. Box not acceptable), and a
daytime phone number with your shipment.
4. For more information and for the location of
the nearest authorized service center please
contact us by one of the following methods:
Who is covered? This warranty is extended to
the original retail purchaser for products
purchased and used in the U.S.A.
• Call us toll-free at 1-866-382-5476
• E-mail us at [email protected]
What is covered? This warranty covers all
defects in material and workmanship in this
product. The following are not covered:
installation/removal costs, damage resulting
from accident, misuse, abuse, neglect, product
modification, improper installation, incorrect
line voltage, unauthorized repair or failure to
follow instructions supplied with the product,
or damage occurring during return shipment
of the product.
Exclusion of Certain Damages: This warranty
is exclusive and in lieu of any and all other
warranties, expressed or implied, including
without limitation the implied warranties of
merchantability and fitness for a particular
purpose and any obligation, liability, right,
claim or remedy in contract or tort, whether
or not arising from the company’s negligence,
actual or imputed. No person or representative
is authorized to assume for the company any
other liability in connection with the sale of
this product. In no event shall the company be
liable for indirect, incidental or consequential
damages.
10
XD5120ꢀOPERATION
Specifications
CDꢀPlayer
FMꢀTuner
Frequency response: 20Hz-20kHz
Channel separation @ 1kHz: >50dB
D/A converter: 1ꢀBit
Tuning range: 87.5MHz-107.9MHz
Usable sensitivity: 15dBf
50dB quieting sensitivity: 23dBf
Stereo separation @ 1kHz: 25dB
Frequency response: 80Hz-10kHz
AMꢀTuner
General
Tuning range: 530kHz-1720kHz
AM sensitivity: 30uV
Frequency response: 80Hz-1.8kHz
Operating voltage: 11-16ꢀVDC,ꢀnegativeꢀground
Speaker output impedance: 4~8ꢀohms
Fuses: 0.5ꢀampꢀfastꢀblowꢀAGC,ꢀ7ꢀampꢀfastꢀblowꢀAGC
Dimensions: 7"ꢀxꢀ7"ꢀxꢀ2"ꢀ(178ꢀxꢀ178ꢀxꢀ51ꢀmm)
Design and specifications subject to change without notice.
CEA-2006 Power Standard Specifications
(reference: 14.4VDC +/- 0.2V, 20Hz~20kHz)
Power Output: 5 Watts RMS x 4 channels at 4 ohms and < 1% THD+N
Signal to Noise Ratio: 65dBA (reference: 1 watt into 4 ohms)
11
XD5120ꢀOPERATION
Troubleshooting
Problem
Cause
Action
Unitꢀwillꢀnotꢀ Yellow or red wire not connected or Check connections for proper
turnꢀon
(noꢀpower)
incorrect voltage
Black wire not connected
Fuse blown
voltage (11~16VDC)
Check connection to ground
Replace fuse
Unitꢀhasꢀpowerꢀ Speaker wires not connected
Check connections at speakers
(butꢀnoꢀsound)
One or more speaker wires touching Insulate all bare speaker wires
each other or touching chassis
ground
from each other and chassis
ground
Unitꢀblowsꢀ
fuses
Yellow or red wire touching chassis Check for pinched wire
ground
Speaker wires touching chassis
ground
Check for pinched wire
Incorrect fuse rating
Use fuse with correct rating
Excessiveꢀ
skipping
Unit is not mounted correctly or
backstrap is not secure
Check mounting sleeve and
backstrap support
Physical defect in media
(CD, CD-R or CD-RW)
Check media for scratches
Errꢀappearsꢀonꢀ Load/Eject operation error or disc is Press eject
display
in upside down
Dual Electronics Corp.
Toll Free: 1-866-382-5476
©2006 Dual Electronics Corp. All rights reserved.
NSA0806-V01
|