Altec Lansing Speaker IM414V2 User Manual

Altec Lansing inMotion Digital Speaker System  
for Zune  
iM414v2  
User Guide  
 
Spread Your Sound Around  
Power  
Congratulations on your purchase of the inMotion iM414 speaker system—  
the portable system with an advanced Class D amplifier, surround effect  
technology and crystal-clear speakers. Its sleek design cradles your Zune  
player securely and attractively as it pumps out full-range, full-bodied sound  
that fills the room. The inMotion systems twin, bass-enhanced speakers  
blend power and clarity. The built-in FM radio expands your listening  
options while the wireless remote increases your freedom. You can plug in  
the inMotion system for AC power, or use batteries to take the music with  
you. So let the music out!  
Use one of the following two options to power your inMotion system:  
AC Power (wall outlet)  
Insert the barrel connector from the power supply into the DC connector  
on the rear of the inMotion system. After this connection is made, insert the  
power supply into a wall outlet.  
DC Power (battery)  
Install 3 AA batteries (not included) into the battery compartments in  
the rear of the inMotion system. Make sure the batteries are installed as  
illustrated in the battery compartment.  
Box Contents  
• inMotion digital speaker system  
• Wireless remote  
Start Playing  
1. Turn on your Zune player.  
2. Turn on the inMotion system by pushing the  
button for  
• Power supply  
about 2 seconds. The LCD screen turns on.  
• Users guide and quick connect instructions  
3. Press the “SOURCE” button until “Zune” is selected on the  
LCD screen.  
iM414v2 model made for:  
4. Use the  
and  
buttons to navigate through your playlist.  
• Zune30GB, 80GB, 8GB, 4GB, Zune HD  
NOTE: To avoid hearing a popping sound when you turn on your inMotion  
system, always turn on your Zune player or other audio source first.  
Connecting Your Zune Player  
Dock your Zune player by sliding it on top of the inMotion system docking  
station. If provided, first install the docking adapter that came with the  
inMotion system. While the docking adapter is not required for proper  
functioning of your Zune player and inMotion system, it may provide a  
better fit.  
Power Off  
Turn off the inMotion system by pushing the  
turns off.  
button. The LCD screen  
1
 
FM Radio  
The inMotion system features a built-in FM radio.  
1. Locate a 3.5 mm stereo cable (not included).  
Activate the FM radio mode:  
Press the “SOURCE” button until “FM” is selected on the LCD screen.  
2. Connect one end of the 3.5 mm stereo cable into the auxiliary  
input jack (AUX) located on the back of the inMotion system,  
and the other end to the headphone or line out jack on your  
alternate audio device.  
Scanning FM radio stations:  
Press and hold the  
incremental manner.  
or  
buttons to scan radio stations in an  
3. Press the “SOURCE” button until “AUX” is selected on the  
Programming FM radio stations:  
LCD screen.  
To program FM radio stations into the wireless remote, follow the steps below:  
4. Set the volume on the audio source at mid-level.  
1. Press the “SOURCE” button until “FM” is selected on the  
5. Set the volume on the inMotion system at the minimum level  
LCD screen.  
and adjust to a comfortable listening level.  
2. Use the  
and  
buttons to tune in the station to  
be preset.  
Adjusting the Volume  
1. Press the “+” button to increase the volume to the desired level.  
2. Press the “–” button to reduce the volume to the desired level.  
3. To program the station in the inMotion system memory,  
press and hold one of the preset buttons (P1, P2, P3) on  
the wireless remote for approximately 3 seconds. The LCD  
screen will display the preset number when a station has been  
successfully programmed.  
Surround Effect  
The inMotion system features surround effect technology that widens  
the stereo image. Activate this feature by pushing the  
wireless remote.  
Once an FM radio station has been programmed, simply press the  
appropriate preset button (P1, P2, P3) on the wireless remote to select it.  
button on the  
NOTE: To re-program a station in the inMotion system memory, simply  
repeat steps 1-3.  
Bass Enhancement Technology  
The inMotion system features bass enhancement technology that delivers  
quality bass without a subwoofer. Activate this feature by pushing the  
“BASS” button on the wireless remote.  
Connecting to an Alternate Audio Source  
The inMotion system includes an auxiliary input jack (AUX) that allows you  
to connect to alternate audio sources, such as other MP3 player models,  
CD players, portable DVD players, and PCs and laptops. To connect the  
inMotion system to an alternate audio source, follow the steps below.  
2
 
Troubleshooting  
Symptom  
Possible Problem  
Solution  
The power supply cord isn’t connected to a  
Insert the barrel connector from the power supply into the DC connector on  
wall outlet and/or the power supply connector the back of the inMotion system. After this connection is made, insert the  
is not plugged into the power supply jack on  
the back of the inMotion system.  
power supply into a wall outlet.  
The Power LED is not lit  
(AC Operation)  
The surge protector (if used) isn’t powered on. If the power supply cord is plugged into a surge protector, make sure the  
surge protector is switched on.  
The wall outlet is not functioning.  
The power isn’t turned on.  
Plug another device into the same wall outlet to confirm the outlet is working.  
Turn on the inMotion system by pushing the power button located to the left  
of the docking station. The LCD screen will turn on.  
Press the “+” button to increase the volume to the desired level.  
The volume is set too low.  
Check the volume level on alternate audio source device and set at mid-level.  
The Zune player is not correctly seated into  
the docking station.  
Turn off the Zune player, remove it from the docking station, reseat it, and turn  
it on again.  
No sound is coming  
from speakers  
If using an alternate audio source, the audio  
source is not properly connected to the  
inMotion system or there is a problem with  
the alternate audio source.  
Follow the instructions in Connecting to an Alternate Audio Source.  
If necessary, try connecting another audio source.  
3
 
Troubleshooting  
Symptom  
Possible Problem  
Solution  
The Zune player is not correctly seated into  
the docking station.  
Turn off the Zune player, remove it from the docking station, reseat it, and  
turn it on again.  
If using an alternate audio source, the audio  
Follow the instructions in Connecting to an Alternate Audio Source.  
There is a crackling sound source is not properly connected to the  
If necessary, try connecting another audio source.  
coming from speakers  
inMotion system or there is a problem with  
the alternate audio source.  
If using a PC or laptop, the operating systems Check the operating system volume level and decrease it if necessary.  
volume level is set too high.  
The inMotion systems volume level is set  
too high.  
Press the “–” button to reduce the volume to the desired level.  
Sound is distorted  
There is radio interference The unit is too close to a radio tower.  
Move the unit to see if the interference goes away.  
Move the GSM cell phone away from the unit.  
The unit is located too close to a GSM  
Intermittent buzzing  
cell phone.  
4
 
Warranty  
ALTEC LANSING ONE-YEAR LIMITED WARRANTY  
What Does the Warranty Cover?  
How Will State Law Affect Your Rights?  
This warranty gives you specific legal rights, and you may also have other rights which  
vary from state to state. Please note that in the European Union, you as a consumer  
might have other legal rights under national legislation of European Union Member  
States governing the sale of Altec Lansings goods. Those rights are not affected by this  
guarantee.  
Altec Lansing warrants that its products shall be free from defects in materials or  
workmanship, with the exceptions stated below.  
What Is the Period of Coverage?  
This warranty runs for one year from the date of purchase. The term of any warranties  
implied by law shall expire when your limited warranty expires. Some states and/or  
Member States in the European Union do not allow limitations on how long an implied  
warranty lasts, so the above limitation may not apply to you.  
The above limited warranties and remedies are sole warranties and remedies available to  
purchaser, if, and to the extent, valid and enforceable under the applicable law.  
DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC EqUIPMENT  
What Does the Warranty Not Cover?  
This symbol on the product or on its packaging indicates that this product  
shall not be treated as household waste. Instead it shall be handed over to  
the applicable collection point for the recycling of electrical and electronic  
equipment. By ensuring this product is disposed of correctly, you will help  
prevent potential negative consequences for the environment and human  
health, which could otherwise be caused by inappropriate waste handling of this  
product. The recycling of materials will help to conserve natural resources. For more  
detailed information about recycling of this product, please contact your local city office  
or your household waste disposal service.  
This warranty does not cover any defect, malfunction or failure that occurs as a result  
of: improper installation; misuse or failure to follow the product directions; abuse; or use  
with improper, unintended or faulty equipment. (For information on proper installation,  
operation and use consult the manual supplied with the product. If you require a  
consequential and incidental damages are not recoverable under this warranty. Some  
states do not allow the exclusion or limitation of incidental or consequential damages,  
so the above limitation or exclusion may not apply to you.  
What Will Altec Lansing Do to Correct the Problem?  
Altec Lansing will, at its option, repair or replace any product that proves to be defective  
in material or workmanship. If your product is no longer being manufactured, or is out of  
stock, at its option, Altec Lansing may replace your product with a similar or better Altec  
Lansing product.  
How to Get Warranty Service  
To get a covered product repaired or replaced, you must contact Altec Lansing during  
the warranty period by email ([email protected]). You must include in your  
email, your name, address, email address, telephone number, date of purchase and  
a complete description of the problem you are experiencing. In the United States, you  
may alternatively contact Altec Lansing by telephone at 1-800-ALTEC88 – please be  
prepared to provide the same information. If the problem appears to be related to a  
defect in material or workmanship, Altec Lansing will provide you a return authorization  
and instructions for return shipment. Return shipments shall be at the customers  
expense, and the return must be accompanied by the original proof of purchase. You  
should insure the shipment as appropriate because you are responsible for the product  
until it arrives at Altec Lansing.  
5
 
HEADqUARTERS 535 Rte. 6 & 209, Milford, PA 18337-0277 • 800-ALTEC-88. 570-296-4434. • Fax 570-296-6887  
EUROPE Scorpius 140, 2132 LR Hoofddorp, The Netherlands  
ASIA/PACIFIC 23/F, Office Tower, Shun Hing Square Diwang Commercial Centre, 5002 Shen Nan Dong Road, Shenzhen, China 518008  
*Sansa and 3 AAA batteries not included.  
*Zune digital media player and 3 AAA batteries not included.  
Specifications subject to change without notice.  
1-year limited warranty (2 years in Europe; see inside for details).  
© 2009 Plantronics, Inc. All rights reserved.  
ALTEC, ALTEC LANSING, the Altec Lansing logo, the horn design, Altec Lansing Hear Whats Next, inMotion, Audio Alignment, iM413 and iM414 are trademarks or registered trademarks of Altec  
Lansing, a division of Plantronics, Inc.  
Plantronics, the logo design and Sound Innovation are trademarks or registered trademarks of Plantronics, Inc.  
All other trademarks appearing herein are the property of their respective owners.  
Designed by Altec Lansing in the USA. Made in China.  
A13846 R01  
 

Abocom Network Card BUD200 User Manual
Accton Technology Switch ES4626 User Manual
Addonics Technologies Computer Drive ADCFASTMS User Manual
AGFA Digital Camera ePHOTO 1280 User Manual
Altinex Stereo Amplifier MT108 102 User Manual
American Standard Indoor Furnishings R116SS User Manual
American Standard Outdoor Shower 3838Y1NEOE5 User Manual
ATI Technologies Lawn Mower Lawn Mower User Manual
Audiovox Satellite Radio 128 6818 User Manual
BB Electronics Network Card 232SDD16 User Manual