INSTALLATION GUIDE
AXIS Q87-E Dual PTZ Network Camera Series
AXIS Q8721-E Dual PTZ Network Camera
AXIS Q8722-E Dual PTZ Network Camera
Safeguards
Please read through this Installation Guide carefully before installing the product. Keep the Installation Guide for
further reference.
• Risk of pinching. Do not touch the product while it is moving.
• Store the Axis product in a dry and ventilated environment.
• Avoid exposing the Axis product to vibration, shocks or heavy pressure and do not install the product on
unstable brackets, unstable or vibrating surfaces or walls, since this could cause damage to the product.
• Only use applicable tools when installing the Axis product; excessive force could cause damage to the
product.
• Do not aim the thermal camera lens toward the sun or other high-intensity radiation sources since this
could cause damage to the sensor.
• Do not use chemicals, caustic agents, or aerosol cleaners. Use a damp cloth for cleaning.
• Only use accessories that comply with the technical specification of the product. These can be provided by
Axis or a third party.
• Use only spare parts provided by or recommended by Axis.
• Do not attempt to repair the product by yourself, contact Axis or your Axis reseller for service matters.
• This Axis product shall be used in compliance with local laws and regulations.
• Do not install the camera near heat sources since fluctuating temperatures may affect thermal image qual-
ity.
• The Axis product should be installed by a trained professional. Please observe relevant national and local
regulations for the installation.
Transportation
• When transporting the Axis product, use the original packaging or equivalent to prevent damage to the
product.
Battery Replacement
This Axis product uses a 3.0 V CR2032 Lithium battery as the power supply for its internal real-time clock (RTC).
Under normal conditions this battery will last for a minimum of 5 years. Low battery power affects the operation
of the RTC, causing it to reset at every power-up. A log message will appear when the battery needs replacing. The
battery should not be replaced unless required!
If the battery does need replacing, please contact www.axis.com/techsup for assistance.
• Dispose of used batteries according to the manufacturer's instructions.
• Risk of explosion if battery is incorrectly replaced.
• Replace only with the same or equivalent battery, as recommended by the manufacturer.
AXIS Q87-E Installation Guide
Page 5
AXIS Q87-E Installation Guide
This Installation Guide provides instructions for installing an AXIS Q8721-E Dual PTZ Network Camera or an AXIS
Q8722-E Dual PTZ Network Camera on your network. For all other aspects of using the product, please see the
User Manuals, available at www.axis.com
Installation Steps
1. Check the package contents against the list below.
3. Install the hardware.
Package Contents
Item
Models/variants/notes
Dual PTZ network camera
AXIS Q8721-E, includes AXIS Q1755 and AXIS Q1921
AXIS Q8722-E, includes AXIS Q1755 and AXIS Q1922
Pan/tilt control unit and motor
Sunshield
Base
Base for dual PTZ network camera
Counterweights
Mounting accessories
Counterweights for balancing pan/tilt control unit (when not using illuminators)
Sunshield mounting kit
Base mounting kit
CD
Installation and Management Software CD
Printed materials
AXIS Q87-E Installation Guide (this document)
Extra serial number labels (2x)
Required accessories
Optional accessories
Power supply (230 V/120 V) with built-in day/night sensor (sold separately)
Wall bracket or column bracket (sold separately)
Corner mount, pole mount
IR Illuminators
Axis Installation Display
See www.axis.com for information on available accessories
Tools needed (not included) RJ45 crimp tool
Allen key set
Ratchet set
Drill for drilling holes in mounting surface
Loctite 243® threadlocker
|