Coleman Camping Equipment 2000001188 User Manual

TM  
KOHNA TENT 18’ X 12’  
MODEL 2000001188  
To Set Up Tent’s Living Quarters (continued)  
Before you begin  
Read all instructions before set up.  
7. Assemble 2 interlocking shock-corded, thin, gray side poles.  
8. Insert gray side poles through sleeves, in front and back of  
the living quarters area of tent as shown. (Fig. 3)  
• Select a level campsite clear of rocks, branches, and other hard  
or sharp objects, to install your tent.  
NOTE: Make sure the side poles are positioned on the  
outside of the black main poles installed earlier.  
WARNING: Keep clear of overhead power lines.  
• Do not set up your tent under trees.  
• For best results in windy conditions, position end of tent into  
the wind.  
• Enlist the help of at least one other person to assist you when  
it is time to assemble the tent.  
Fig. 3  
Sleeve at back of  
Living Quarters  
Sleeve at front  
of Living  
Quarters  
Parts and Components  
Description  
Living Quarters, Main Poles, Black (2)  
Living Quarters, Side Poles, Thin, Gray (2)  
Screen Room Poles, Gray (2)  
Rainfly  
Part Number  
5010000384  
5010000383  
5010000382  
5010000385  
Thin, Gray,  
Side Poles  
To Set Up Tent’s Living Quarters  
9. Insert one end of each gray side pole into pins in side of tent  
forming an “X”. (Fig. 4 & Fig. 4A)  
10. Go to opposite end of each pole and gradually apply pressure  
to the pole forming an arch. Insert the pin into the pole end  
at opposite side of tent forming an “X”. (Fig. 4)  
11. Attach large frame clips along edges of upper four corners  
tent to connect black main poles and gray side  
1. Unfold tent and spread out on a clean, level surface with the  
door facing the desired direction. (Fig. 1)  
2. Assemble main tent poles by interlocking both longer, black  
shock-corded, poles.  
3. Insert black main poles through sleeves, in top of the Living  
Quarters area of tent, forming an “X” as shown. (Fig. 1)  
poles where they intersect. (Fig. 4 & 4B)  
Fig. 1  
Main Tent Poles  
Sleeves  
4B  
Door  
Living Quarters  
Screen Room  
4. Insert one end of each black main pole into pins in front  
corners of tent. (Fig. 2 & 2A)  
5. Go to opposite end of each pole and gradually apply pressure  
to the pole forming an arch. Insert the pin into the pole end  
at the tent corners. (Fig. 2 & 2A)  
Fig. 4  
4A  
2A  
To Set Up Tent’s Screen Room  
1. Assemble screen room poles by interlocking both longer,  
gray, shock-corded poles.  
Fig. 2  
2. Insert gray poles through both sleeves on screen room as  
shown. (Fig. 5)  
Sleeve at back of  
Screen Room  
Sleeve at front of  
Screen Room  
Door  
6. Attach smaller frame clips along edges of  
tent to black main poles.(Fig. 2B)  
Gray Screen  
Room Poles  
NOTE: DO NOT attach the larger frame  
clips located near the top of the tent living  
quarters. They will be used in later assembly.  
Fig. 5  
2B  
(continued on other side)  
 

Compaq Projector iP 60E User Manual
Cooper Lighting Landscape Lighting 50 400W User Manual
Craftsman Drill 1372191 User Manual
Craftsman Saw 1132472T0 User Manual
Crosley Refrigerator 2212430 User Manual
Dell Server E21S001 User Manual
Dymo Printer 350D User Manual
Eagle Electronics Fish Finder 642c User Manual
Ecom Instruments PDAs Smartphones iroc x20 Ex User Manual
Freecom Technologies Computer Drive FHD xx User Manual