Carving
Station
FL-2206
Rev. 7 (4/08)
Page 1 of 2
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Model: CSH-122-10 Series, 120 and 240 Volt
ELECTRICAL SPECIFICATIONS:
Model No.
Volts
Watts
Amps
Hertz
Phase
NEMA
Service
CSH-122-10
120
1100
9.2
60
1
5-15
15 AMP
CSH-122-10
240
1150
4.8
60
1
6-15
15 AMP
HOOD "ON/OFF"
THERMOSTAT BEZEL
0848-063
OFF
HEATERS "ON/OFF"
THERMOSTAT KNOB
0595-002
HOW TO OPERATE UNIT:
CLEANING INSTRUCTIONS:
1. Plug cord into proper wall outlet.
2. Push thermostat switch “ON” and turn thermostat
to no. 10.
3. Preheat for 30 minutes; then add cutting board
and/or pans to the heated base.
4. Push lamp switch(es) to “ON” for additional
heat.
1. Remove power cord from wall outlet.
2. DO NOT immerse unit in water.
3. DO NOT get water on controls.
4. Wipe cooled exterior with soap and water.
NOTE: Proper food holding temperature is 140°F
5. DO NOT use abrasives or harsh
chemicals.
(60°C) or higher.
REPLACEMENT PARTS:
For uncovered pans or product:
Leave thermostat on no. 10 setting.
Lamp, Red (250 Watts) ................................ 0820-001
Lamp, White (250 Watts)............................. 0820-033
Lamp, Red (275 Watts/240 Volts)................ 0820-014
Cutting Board............................................... 1004-018
Legs - Adjustable ......................................... 1206-027
Socket........................................................... 0822-037
For covered pans or product:
Turn the thermostat to no. 6 setting.
5. Push switches and turn thermostat “OFF” when
done.
|