CD PROGRAMMED PLAY
This function allows the tracks to be played in a programmed sequence.
1. Under CD stop or playing condition, press the PROG. BUTTON (#2). The CD TRACK DISPLAY (#16) will
display “01” and the PROG on the display will flash.
2. Press the CD F.FWD BUTTON (#7) or CD REW BUTTON (#6) to select the song to be programmed.
3. Press the PROG. BUTTON(#2) again to store selection. The CD TRACK DISPLAY (#16) will advance to “02”.
4. Press the CD F. FWD BUTTON(#7) or CD REW BUTTON(#6) to select the next song to be programmed and
press the PROG. BUTTON(#2) to store selection.
5. The max. programmable tracks reaches as 20 tracks merely for memory save.
6. Press CD STOP BUTTON (#5) to end programming and return to normal play mode.
7. To check the programmed tracks, press PROG. BUTTON(#2) continuous to show all the programmed songs.
The CD TRACK DISPLAY(#16) will display the program number first and then followed by the flashing track
number.
8. Press CD PLAY/PAUSE BUTTON (#8) to begin programmed play. The first track in program will appear in the
CD TRACK DISPLAY(#16) and the” PROG” will light steadily.
9. To cancel programmed play, press the CD STOP BUTTON (#5).
10. As long as the unit remains on and the CD DOOR(#21) is not opened, you can resume programmed play any
time by pressing the PROG. BUTTON(#2) and then CD PLAY/PAUSE BUTTON(#8) in stop condition.
RADIO RECEPTION
1. Set the FUNCTION SELECTOR(#23) to the "RADIO" position.
2. Set the BAND SELECTOR(#24) to either "AM", or “FM” for the desired radio band. To receive a weak (noisy)
FM station, set the BAND SELECTOR(#24) to the “FM” position. The reception may be improved, but the
sound will be monaural (MONO).
3. While you switch the BAND SELECTOR(#24) to “FM St”, once you get the right FM station, then the FM
STEREO INDICATOR(#20) will be getting GREEN
4. Adjust the TUNING KNOB(#10) to obtain the desired radio station.
5. Adjust the VOLUME CONTROL (#22) to obtain the desired sound level.
6. When you wish to turn off the Radio, set the POWER ON/OFF BUTTON (#11) to the "OFF" position or switch
the FUNCTION SELECTOR(#23) to CD / AUX-IN position.
TIPS FOR GOOD RADIO RECEPTION
1. To insure maximum FM tuner sensitivity, the TELESCOPIC ANTENNA(#9) should be fully extended and
rotated to obtain the best possible reception. The FM STEREO INDICATOR(#20) will light steadily when a
stereo program is being received.
2. When tuning in AM reception, be sure to place the unit in a vertical position. To insure the maximum AM
sensitivity, try repositioning the unit until the best reception is obtained.
AUX IN FUNCTION
1. Set the FUNCTION SELECTOR(#23) to AUX IN position
2. Plug the external signal jack into the AUX-IN jack (#12) , then the unit will be used as speaker
3. Adjust the volume by the VOLUME CONTROL(#22)
4. Stop this function ,power off the unit or switch the FUNCTION SELECTOR(#23) to other position
Remark: While using this function , other functional key are invalid except the VOLUME CONTROL( #22)
USING HEADPHONES (NOT INCLUDED)
Inserting the plug of your headphones into the HEADPHONE JACK (#13) will enable you to listen to the CD and
Radio in private. When using headphones, the SPEAKER (#17) will be disconnected.
READ THIS IMPORTANT INFORMATION BEFORE USING YOUR HEADPHONES
1. Avoid extended play at very high volume as it may impair your hearing.
2. If you experience ringing in your ears, reduce the volume or shut off your unit.
3. Do not use while driving a motorized vehicle. This is dangerous and also illegal in some areas.
4. Keep the volume at a reasonable level even if your headset is an open-air type designed to allow you to hear
outside sounds. Please note excessively high volume may still block outside sounds.
6
