Dual Speed Switch 16
DESCRIPTION
Code: 8E4090
Your applications require VLAN, Trunking or QoS?
You need advanced diagnostic functions or
network analysis?
ꢀ 16 RJ 45 10BaseT/100BaseTx , VLAN
support, Trunk and QoS Priority
ꢀ Automatic MDI-X to MDI (Cross) on all ports
ꢀ Full-duplex switch for 10/100 Mbps
groups interconnection
Get all this at the same time!
Dual Speed Switch16 is the suitable, compact and
performing solution!
ꢀ Store and Forward technology
ꢀ Full speed filtering and forwarding rate
ꢀ Table memory for 8192 addresses
ꢀ 1,5MByte Buffer Memory
Any of the 16 ports is 10/100Mbps Autosensing.
Speed and operating mode are automatically detected
and selected.
ꢀ IEEE 802.3, 802.3u, 802.3x, 802.1p,
802.1q
Furthermore any of the 16 ports can be connected as
“normal” or Uplink port (automatic MDI/MDI-x)
providing easy and direct connection to other hubs or
switches on the network.
ꢀ 4 trunk support (up to 4 ports) up to 800
Mbps in full duplex, with load balance
and fault tolerance support
ꢀ Up to 32 VLAN group support with VLAN
port-based, 802.1Q tag VLAN and Leaky
VLAN support
This device offers advanced functionalities that
increase the network performances.
It is possible to define up to 32 VLAN with the VLAN
tag support and activate the Port Trunking to carry out
high traffic backbone.
ꢀ Priority management support with three
different service classes (CoS): Port
based, 802.1p priority tag, TCP/IP
header’s TOD/DS classifier
Thanks to the priority functions, the QoS and the
IGMP snooping, Dual Speed Switch 16 is particularly
suitable for the VoIP and Multimedia applications
where the traffic management is very important.
ꢀ IMGPv1 and v2 port snooping support
ꢀ Broadcast Storm filtering support
ꢀ Port Security support for restrictions to
port access
Network activity, speed and status of each port is
shown by led indicators on the front panel. The switch
has got diagnostic functions to determine the ports
and cable status and the signal quality.
ꢀ Parameters and monitor configuration
for port with MIB Tx/Rx Packets
counters, CRC, Collisions
ꢀ Led Indicators: Power, Link/Activity,
10Mbps/100Mbps, Full-duplex
ꢀ Metal chassis
Easy configuration through the simple utility with
graphic interface directly fron the LAN network.
ꢀ Desktop
ꢀ 19” rack mounting kit included
ꢀ 110-240 Vac Integrated power supply
ꢀ 20Watt consumption
ꢀ 273 x 166 x 43 mm; 1,5 Kg.
ꢀ Operating temperature 0 to 50°C
ꢀ Humidity 5% to 95% non condensing
ꢀ CE mark
Dual Speed Switch 16 06.12.2005
|