Washer
PRODUCT MODEL NUMBERS
RECESSED AREA AND CLOSET INSTALLATION
ETW4400V
For closet installation, with a door, the minimum ventilation openings in the top and
bottom of the door are required (view 2). Louvered doors with equivalent air ventilation
openings in the top and bottom are acceptable.
Electrical: 120-volt, 60-Hz, AC-only,
15- or 20-amp. electrical supply. A time-delay fuse
or circuit breaker and separate circuit is
recommended.
"
"
"
"
"
"
"
"
"
"
"
"
1
2
3
Front view
Side view
Closet door with vents
DRAIN SYSTEM OPTIONS
Standpipe drain system - wall or floor (view 1 & 2)
The standpipe drain requires a minimum diameter standpipe of
2 in. (5 cm). The minimum carry-away capacity can be no less
than 17 gal. (64 L) per minute.
The top of the standpipe must be at least 39 in. (99 cm) high
and no higher than 96 in. (2.4 m) from the bottom of the
washer.
Laundry tub drain system (view 1)
The laundry tub needs a minimum
20 gal. (76 L) capacity. The top of the
laundry tub must be at least 39 in.
(99 cm) above the floor and no higher
than 96 in. (2.4 m) from the bottom of
the washer.
Floor drain system (view 2)
The floor drain system requires a siphon
break that may be purchased separately.
The siphon break must be a minimum of
28 in. (71 cm) from the bottom of the
washer. Additional hoses might be
needed.
39"
(99 cm)
1
2
1
2
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10150593
04-15-08
|