Edelbrock Automobile Parts 15010 User Manual

OIL SUPPLY ADAPTER  
For Honda/Acura B-Series and D-Series Engines  
Catalog #15010  
®
INSTALLATION INSTRUCTIONS  
PLEASE study these instructions carefully before beginning this installation. Most installations can be accomplished with common tools and  
procedures. However, you should be familiar with and comfortable working on your vehicle. If you do not feel comfortable performing this installation,  
it is recommended to have the installation completed by a qualified mechanic. If you have any questions, please call our Technical Hotline at:  
1-800-416-8628, 7:00 am - 5:00 pm, Pacific Standard Time, Monday through Friday or e-mail us at [email protected].  
IMPORTANT NOTE: Proper installation is the responsibility of the installer. Improper installation  
will void your warranty and may result in poor performance and engine or vehicle damage.  
DESCRIPTION: Designed for Honda/Acura B-Series and D-Series engines equipped with or without a factory water-cooled oil cooler, this kit can  
supply oil for a VTEC conversion or for a turbocharger. The adapter also includes a port for an oil pressure gauge. The adapter fits directly between  
the engine block, or factory oil cooler, and the stock oil filter.  
KIT CONTENTS:  
1 Oil Supply Sandwich Adapter Assembly  
INSTALLATION PROCEDURE  
1. Remove the stock oil filter (replace with a new filter).  
2. Install the Oil Supply Sandwich Adapter in place of the stock oil filter.  
3. Make sure the O-Ring is facing toward the engine block, and the threaded stud with ½” hex opening is facing out (See Fig. 1).  
4. Although it is a tight fit, the aluminum housing and the threaded center stud will turn independently of each other. Start the assembly onto the  
engine by hand at first. Then, while holding the outer housing in position, tighten the threaded center with a ½” Allen wrench. Make sure to  
position the -6 AN (blue) fitting so that it is facing toward the driver’s side, pointing upward slightly (about the 10 o’clock position) (See Fig. 1).  
5. Install a new oil filter.  
6. Attach an appropriate supply line for the accessory requiring an oil supply. A supply line can be attached using a -6AN (female) fitting. You may  
also attach an oil pressure gauge line to the 1/8 NPT port on the Oil Supply Adapter by removing the 1/8 NPT plug, and installing your gauge  
fitting.  
-6AN Fitting  
Tighten Using  
1/2” Allen  
Wrench  
1/8 NPT Plug  
(Not Visible)  
Fig. 1  
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503  
Tech Line: 1-800-416-8628 • E-Mail: [email protected]  
Catalog #15010  
Rev. 11/06 - RS/mc  
©2006 Edelbrock Corporation  
Brochure #63-0250  
 

Edimax Technology Switch Two console 16 port PS 2 KVM Switch User Manual
Extron electronic Stereo Amplifier MPA 122 User Manual
FieldServer Computer Drive FS 8700 64 User Manual
FireplaceXtrordinair Indoor Fireplace 1080 User Manual
Fisher Price Baby Toy 73455 User Manual
Force10 Networks Switch CC C BLNK LC User Manual
GE Microwave Oven JVM58 User Manual
GE Monogram Range ZGU484LGPSS User Manual
Generac Power Systems Portable Generator 05681 User Manual
GE Range 183D5580P236 User Manual