Euro Pro Vacuum Cleaner V1925H User Manual

Model  
V1925H  
ONE (1) YEAR LIMITED WARRANTY  
EURO-PRO Operating LLC warrants this product to be free from defects in material and  
workmanship for a period of one (1) year from the date of the original purchase, when utilized for  
normal household use, subject to the following conditions, exclusions and exceptions.  
If your appliance fails to operate properly while in use under normal household conditions within  
the warranty period, return the complete appliance and accessories, freight prepaid to:  
Cordless Sweeper  
In US:  
EURO-PRO Operating LLC, 94 Main Mill Street, Door 16, Plattsburgh, N.Y. 12901  
In Canada: EURO-PRO Operating LLC, 4400 Bois Franc, St Laurent, Qc, H9S 1A7  
with No Touch Dust Cup  
If the appliance is found to be defective in material or workmanship, EURO-PRO Operating LLC  
will repair or replace it free of charge. Proof of purchase date must be included. *  
OWNER’S MANUAL  
Model: V1925H  
Non-durable parts including, without limitation, dust cups and brushes which normally require  
replacement are specifically excluded from warranty.  
4.8 Volt d.c  
The liability of EURO-PRO Operating LLC is limited solely to the cost of the repair or  
replacement of the unit at our option. This warranty does not cover normal wear of parts and  
does not apply to any unit that has been tampered with or used for commercial purposes. This  
limited warranty does not cover damage caused by misuse, abuse, negligent handling or  
damage due to faulty packaging or mishandling in transit. This warranty does not cover damage  
or defects caused by or resulting from damages from shipping or repairs, service or alterations to  
the product or any of its parts, which have been performed by a repair person not authorized by  
EURO-PRO Operating LLC.  
This warranty is extended to the original purchaser of the unit and excludes all other legal and/or  
conventional warranties. The responsibility of EURO-PRO Operating LLC if any, is limited to the  
specific obligations expressly assumed by it under the terms of the limited warranty. In no event  
is EURO-PRO Operating LLC liable for incidental or consequential damages of any nature  
whatsoever. Some states/provinces do not permit the exclusion or limitation of incidental or  
consequential damages, so the above may not apply to you.  
This warranty gives you specific legal rights, and you may also have other rights which vary from  
state to state or province to province.  
*Important: Carefully pack item to avoid damage in shipping. Be sure to include proof  
of purchase date and to attach tag to item before packing with your name, complete  
address and phone number with a note giving purchase information, model number and  
what you believe is the problem with item. We recommend you insure the package (as  
damage in shipping is not covered by your warranty). Mark the outside of your package  
“ATTENTION CUSTOMER SERVICE”. We are constantly striving to improve our products,  
therefore the specifications contained herein are subject to change without notice.  
OWNERSHIP REGISTRATION CARD  
Please fill out and mail the product registration card within ten (10) days of purchase. The  
registration will enable us to contact you in the unlikely event of a product safety notification. By  
returning this card you acknowledge to have read and understood the instructions for use, and  
warnings set forth in the accompanying instructions. RETURN TO:  
EURO-PRO Operating LLC, 94 MAIN MILL STREET, DOOR 16, PLATTSBURGH, NY 12901  
V1925H  
_____________________________________________________________________  
Appliance model  
_____________________________________________________________________  
Date purchased  
Name of store  
_____________________________________________________________________  
Owner’s name  
_____________________________________________________________________  
USA:  
EURO-PRO OPERATING LLC  
Canada: EURO-PRO OPERATING LLC  
4400 Bois Franc  
94 Main Mill Street, Door 16  
Plattsburg, NY 12901  
St. Laurent, QC H4S 1A7  
Address  
City  
State  
Zip Code  
Tel.: 1 (800) 798-7398  
COPYRIGHT © EURO-PRO OPERATING LLC 2006  
11  
Printed in China  
 
Getting To Know Your Cordless Sweeper  
Maintenance & Cleaning Instructions  
Maintenance and Cleaning Instructions  
To improve the performance and life of your unit, we recommend you do the  
following:  
1. Periodically remove the transparent brush cover on the front of the cordless  
sweeper and remove any build up of lint, hair or fiber on the rotating brush. To  
remove the cover - grip the cover from the bottom, pull out and upward until the  
cover unlocks from the side slots and tabs located on the top of the sweeper.  
Carefully cut away threads or hair with scissors. (Fig. 9)  
Fig. 9  
2. Once a month clean the unit with a dry cloth, including the chamber which the  
dust cup container fits into. Remove any hair, fiber or other materials that may  
have built up in the chamber, and on the rotating brush.  
3. Do not use abrasive materials to clean the sweeper. Do not immerse the unit  
in water.  
1. Handle  
2. Handle Extension Tube  
3. Extension Tube  
4. Dust Cup Empty Button  
5. Lower Extension Tube  
6. Steering Pivot  
4. Do not pick up liquids or use on wet floors.  
5. Do not use on concrete, tar or similar rough surfaces.  
6. Do not pick up pieces of string or fabrics with the sweeper.  
7. Do not clean tasseled or frayed carpets with the sweeper.  
Caution: Do not accidentally turn unit on while cleaning.  
Caution: Any electronic or electrical appliance should not be stored in or  
exposed to areas of high heat or humidity. Do not store your cordless sweeper  
close to stoves, radiators, furnaces or in a bathroom or bathing area.  
7. On/Off Button  
8. Charging Light Indicator  
9. Transparent Brush Cover  
10. Rotating Brush  
11. Dust Cup Container  
12. Dust Cup Release Button  
* Illustrations may differ from actual product.  
NOTE: The cordless sweeper is shipped with the batteries uncharged.  
Charging of the unit for 20 hours prior to first use is required.  
Use replacement battery # XBV1925H only.  
9
2
 
Operating Instructions  
Operating Instructions  
Assembling Your Cordless Sweeper  
Cleaning The Dust Cup Container  
To achieve the best performance, empty the dust cup container after each use.  
1. Press the dust cup release button with your foot. (Fig. 7)  
Note: Be careful not to accidentally turn the unit on.  
Your cordless sweeper will require very little assembly. You should remove it from the  
carton and familiarize yourself with all the components listed per the exploded view  
drawing (page 2). This will help you in the assembly and operation of your cordless  
sweeper.  
Note: The charging adapter is shipped inside the packaging.  
Note: The lower extension tube has the dust cup empty button on it. This tube  
should be inserted into the steering pivot.  
1. Insert the lower extension tube into the steering pivot so that the tab snaps into  
place. (Fig. 1a) Push the extension tube into the lower extension tube. (Fig. 1b)  
Insert the extension tube into the lower extension tube. (Fig. 1) Insert the handle  
into the handle extension tube.  
Fig. 7  
2. Lift out the dust cup container, which is connected to the steering pivot. Hold  
over a trash bin and push down on the dust cup empty button located on the  
lower extension tube. (Fig. 8)  
Dust Cup  
Empty Button  
Insert into  
steering pivot  
Fig. 1b  
Fig. 1a  
Fig. 8  
3. Replace the dust cup by positioning it onto the sweeper power head and press  
down firmly until it snaps back into place.  
Fig. 1  
2. Place the handle into the upward storage position.  
3
8
 
Operating Instructions  
Operating Instructions  
How To Operate Your Cordless Sweeper  
Charging Instructions  
1. Before using, please ensure that the cordless sweeper has been initially  
charged for 20 hours. Your cordless sweeper will only operate properly when the  
batteries are fully charged. Your sweeper will operate for varying lengths of time  
on a full charge. This will depend upon the type of surface being cleaned (longer  
operating time on bare floors vs. carpets).  
1. Connect the charger plug to the charging jack or hole on the backside of the  
sweeper. Plug the charging adapter into the wall outlet. (120V., 60Hz.) Use only  
K-TEC Charger KA12D075015023U. (Fig. 2)  
2. Push the On/Off switch to operate the unit. To turn off, press switch again. (Fig. 5)  
Charging  
Light  
Indicator  
On/Off Button  
Fig. 2  
Fig. 5  
2. This cordless sweeper is powered by Ni-Cd batteries. Before first use, they must  
3. To release the handle to a comfortable position, gently apply pressure to  
the top of the sweeper head with your foot while pulling back on the handle.  
(Fig. 6)  
be charged for a minimum 20 hours.  
3. When recharging the unit, the unit must be turned off.  
4. The charging light indicator on the top of the sweeper will illuminate to indicate  
that the sweeper is properly charging.  
5. To recharge, repeat step #1 above. Charging times will vary depending upon the  
amount of usage between charging cycles.  
Note: If when you place the sweeper to recharge and the charging indicator light  
does NOT illuminate, then press the On/Off button once to turn the sweeper off. The  
charging indicator light should now light up.  
Note: Peak performance may only be realized after the unit has been charged and  
discharged two (2) or three (3) times.  
Important: To maintain peak performance of your cordless sweeper, it is  
recommended that the unit be fully discharged, then completely re-charged at least  
once a month.  
Fig. 6  
Caution:  
Use only the adaptor supplied with the sweeper.  
Do not clean the sweeper while unit is charging.  
Do not attempt to remove the battery pack from the unit to charge it.  
Never attempt to throw the battery pack or unit into a fire or incinerate it.  
Do not attempt to remove or damage the battery casing.  
7
4
 
Operating Instructions  
Operating Instructions  
To Maximize The Life Of Your Ni-cd Batteries  
Removal of Battery Pack  
1. Turn unit over so that the base is facing upwards.  
1. Charge for a minimum of 20 hours before initial use. Failure to do so will reduce  
the product’s battery life significantly.  
Be careful not to turn the unit ON.  
2. Do not store the unit with the charging adaptor attached and plugged in.  
2. Push in locking tab and lift off the battery compartment cover. (Fig. 3)  
3. Only recharge when the batteries are fully discharged (or as close to fully  
discharged as possible).  
Battery Pack  
Compartment Cover  
4. Do not store in areas of high temperature or humidity.  
Locking Tab  
5. After three (3) months of storage, the product should be fully discharged and then  
recharged to maximize battery power.  
6. Use only the charger supplied with the product. If other chargers are used, the  
batteries can fail causing damage to the battery, product or personal property.  
7. Ni-Cd batteries have a long useful life but at some time they will need to be  
replaced. To purchase replacement batteries and parts call customer service at:  
1 (800) 798-7398.  
Fig. 3  
Note: If the product has never been used or has been stored for an extended period  
of time without use – it will take several complete charge and discharge cycles to  
realize the full operational time of your product.  
3. Carefully lift out the battery pack and disconnect the wire terminals by pulling  
apart the wire terminal connector. Remove the battery pack from the unit. (Fig. 4)  
Battery Removal & Disposal  
Wire Terminal Connector  
Note: If uncertain as to how to remove your battery pack, we suggest you take your  
sweeper to a reputable small appliance service technician to have this service  
performed.  
Follow the steps in “Removal of Battery Pack” when battery removal is required.  
This sweeper is equipped with Ni-Cd batteries and you need to dispose of them  
properly. When the batteries are no longer good for use, they must be removed from  
the sweeper for disposal. Do not remove the batteries for any reason other than  
disposal of them. Call your nearest recycling center for information on the  
recycling and disposal of Ni-Cd batteries.  
Fig. 4  
4. Connect the wire terminal connector from the unit to the wire terminal connector  
of the new battery pack, and replace the battery pack into the unit. Replace the  
cover and press until it snaps in place.  
Warning: You must never use ordinary batteries for replacement as these may leak  
and cause damage. Use only battery pack XBV1925H provided for replacement.  
5. Follow instructions for initial battery charging. Please call customer service at  
1 (800) 798-7398 if there are any problems removing batteries.  
DO NOT ATTEMPT TO REPLACE THE BATTERIES USED IN THIS PRODUCT  
WITH ANY OTHER TYPE OF BATTERY.  
Important: This appliance contains Ni-Cd batteries. The batteries must be  
recycled or disposed of in accordance with local regulations. Please consult  
your Yellow Pages or local recycling center for more information.  
5
6
 

Electro Voice Musical Instrument Amplifier GS 1000 User Manual
Everpure Water System DEV9105 41 User Manual
Excalibur electronic Games LCD CHESS User Manual
FireplaceXtrordinair Indoor Fireplace 1924E User Manual
Frigidaire Ventilation Hood PLHV42P8KC User Manual
Fujitsu Printer FTP 631MCL351 User Manual
GE Clothes Dryer UPSQ495ET User Manual
GE Dishwasher GLC4000 User Manual
GE Thermostat RAK148D1 User Manual
Gladiator Garageworks Tool Storage 2253694A User Manual