MTP 15HD RS Series • Setup Guide
This card provides quick start instructions for an experienced installer to set up and operate any of the MTP VGA video and RS‑232 transmission
systems.
Unjumpered for
One-way (Default)
Pre-installation — RS-232 Jumper
The receiver’s RS‑232 circuits are factory‑set to be one‑way, transmitter to receiver. If the system has only one
receiver, jumper JMP 1 on the main board can be set for two‑way communication as shown at right.
JMP3
JMP2
JMP1
Installation
Step 1 — Mounting
Jumpered for
Two-way
Turn off or disconnect all equipment power sources and mount the MTP transmitter and up to eight receivers
as required.
RS-232
Tx Rx
Step 2 — Transmitter Inputs
•
•
•
Connect a computer (VGA) video source to the Input connector.
Connect a VGA monitor to the Monitor connector.
Plug an RS‑232 device into the RS‑232 port. Wire the connector as shown below.
INPUT
MONITOR
Tx
Rx
Receive
Transmit
Ground
Connected
RS-232
Device Pins
Pins:
12345678
MTP
Pins
T568A
Wire Color
T568B
Wire Color
Gnd
Pin
1
White-green
White-orange
2
3
4
5
Green
Orange
Step 3 — TP Cables Between Units
White-orange
Blue
White-green
Blue
•
Terminate a TP cable as shown at right. Connect it between the transmitter’s Output port and the
receiver’s Input port (both ends must match).
White-blue
White-blue
6
7
8
Orange
Green
White-brown
Brown
White-brown
Brown
Insert Twisted
Pair Wires
NOTE: If the unit is labeled “C7,” only CAT 7 cable should be used.
NOTE: If you are using Enhanced Skew-Free™
A/V cable, use the TIA/EIA T568A standard only.
•
For daisy-chaining, connect up to eight TP cables between a receiver’s Buffered
Output port and a daisy‑chained receiver’s Input port.
RS-232
Tx Rx
Step 4 — Receiver Outputs
•
•
Connect a VGA monitor to the Output connector.
Plug an RS‑232 device into the RS‑232 port. Wire the connector as shown in step 2, above.
OUTPUT
Step 5 — Receiver DIP Switches
•
•
H Sync and V. Sync switches — Set these switches up for positive sync or down for negative sync.
ON
Composite Sync, (SOG), and Video switches — Set these switches as shown in the following table to output the
indicated format.
1
2
3
4
5
6
Output Format
C Sync
SOG
Video
RGBHV
RGBS
RGsB
Component*
S‑Video*
Composite*
NOTE: * Input video format must match.
•
End Unit switch — Set this switch up if either of the following is true:
•
•
The receiver being configured is the only receiver connected to the transmitter.
The receiver being configured is the last receiver in a daisy‑chained system.
|