THE FENDER® METALHEAD™ MH–412ST & MH–412SL LOUDSPEAKER ENCLOSURES
Your new Metalhead™ MH–412ST or MH–412SL loudspeaker
enclosure is constructed from 3/4" (1.9 cm) 13-ply birch plywood and is
SPECIFICATIONS
capable of handling 400 Watts. Each enclosure features four 12"
(30.5cm) speakers with 54 oz (1.53 kg) magnets. MH–412 speakers
were designed to complement the Fender® Metalhead™ MH-500
amplifier, but they can be used with any professional quality instrument
amplifier.* Read these instructions and your amplifier manual before
making connections.
PART NUMBERS
2282900000 (MH-412ST)
2282800000 (MH-412SL)
DRIVERS
Four 12" (30.5 cm) steel frame drivers
1 3/4" (4.5 cm) voice coils
54 oz (1.53 kg) magnets
CABINET
3/4" (1.9 cm) 13-ply birch plywood
99 dB, 1 Watt - 1 Meter
400 Watts
Connecting Metalhead™ MH–412 Speakers
SENSITIVITY
Connect each MH-412 to a speaker output jack on your
amplifier. Use standard speaker cable (16 gauge minimum)
POWER HANDLING
IMPEDANCE
with 1/4" phone plugs
.
4Ω
Connect a speaker impedance total that matches your
amplifier’s minimum impedance rating for maximum power
output. CAUTION: Never connect a speaker impedance
load less than the minimum rating of your amplifier to
prevent damage to your equipment.
CONNECTIONS
ENCLOSURE VOLUME
1/4" High Current Input Jack
3
VB = 5.5 ft (155 L) (MH-412ST)
3
VB = 5.1 ft (145 L) (MH-412SL)
*The Fender® Metalhead™ MH–500 amplifier features a SPEAKER SELECT
switch that optimizes speaker output for either a 4– or 2–ohm load:
DIMENSIONS
Height:
30 in (76.2 cm)
30 in (76.2 cm)
15 in (38.1 cm)
4–ohm load = One MH-412 speaker
2–ohm load = Two MH-412 speakers
Width:
Depth:
WEIGHT
106 lb (48 kg)
Product specifications are subject to change without notice.
A PRODUCT OF:
FENDER MUSICAL INSTRUMENTS CORPORATION
CORONA, CALIFORNIA USA
Fender® and Metalhead™ are trademarks of FMIC.
© 2004 FMIC. All rights reserved.
P/N 065479 REV A
|