Overhead Gym
Support
Straps
Tubes
Straps
Straps
2
• Locate both straps on the bottom of one
of the tubes.
• Fit the ends of each strap into the
support post.
Slots
Quilt
Supports
1
• Turn the support over and fasten
the straps.
• Place the quilt, print side up, on a
flat surface.
• Repeat this procedure to attach the
remaining tube ends to the supports.
• Fit the "T" end of each strap on the quilt
through the slots in the supports. Pull up
on the quilt to be sure it is secure.
3
Convert for
Tummy-Time Play
3
• Squeeze the stem to inflate the ball.
• Fasten the toys and inflatable ball to the
straps on the arches.
• Remove the toys and inflatable ball from
the straps on the arches.
• Place the toys on the quilt for baby.
Fisher Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2009 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
P5331pr-0920
PRINTED IN CHINA
4
Crawl-Through Fun
Straps
Support
Post
Sleeve
Tube
2
• Position the supports so the slots are
facing inward.
• Locate both straps on the bottom of one
of the tubes.
• Fit the ends of each strap into the
support post.
• Turn the support over and fasten
the straps.
• Repeat this procedure to attach the
remaining tube ends to the supports.
1
• Slide each tube through the sleeve in each
side of the quilt.
5
Care
• Machine wash the play quilt in cold water
on the gentle cycle. Do not use bleach.
Tumble dry on low heat.
• Surface wash the tubes, toys, ball and
supports with a mild cleaning solution
and damp cloth. Do not use bleach.
Rinse clean to remove residue.
3
• Fit the plastic tabs on each end of the
quilt into the slots in the supports.
4
•
Attach the toys and the ball to the fasteners
on the sleeves.
6
|