Model PDXRC
Operating Instructions
HAND HELD REMOTE CONTROL
This kit contains
Qty
For Use With Packaged Terminal Units
2. Remote control
3. AAA batteries
4. Fill piece
1
2
1
2
Please read these instructions completely before
attempting installation.
NOTE: This kit is for use with PD model Friedrich
PTAC units with SD or later suffixes. For example:
PDE09K3SD. This kit will not work with prior models.
5. Screws #8 x 3/8
Preparing unit for remote control use
Remote Control Operation
NOTE: The remote control operation requires the control
panel door of the PTAC to remain open or be removed
from the unit. If electing to use the fill piece, follow Steps
1-4. Otherwise, proceed straight to Step 5.
POWER - Press the Power button once. The unit will automat-
ically turn on in the mode and fan speed it was last left on.
To set mode of operation
COOL - Press the Cool button to automatically switch the
operating mode to COOL.
1) Remove the control panel door from the front grille by
unhinging it from the grille. This is done by pushing
back on the top portion of the door until the door is
released from the hinges.
HEAT - Press the Heat button to automatically switch the
operating mode to Heat.
FAN ONLY - Press the Fan Only button if you want to run
2) Remove the front grille from the unit.
the fan only.
3) Screw the fill piece to the unit using the screws provid-
COOLER - Press the Cooler button to raise the tempera-
ture setting one degree.
ed into the two screw holes above the control panel.
4) Reattach the front grille.
WARMER - Press the Warmer button to lower the tem-
perature setting one degree.
5) Turn on the PTAC unit
6) Put batteries in the remote
To adjust fan speed
7) The remote control is now ready for operation.
Low Fan - Press the Low Fan button to adjust the fan
speed to low.
8) Your unit should come already enabled to receive the
remote signal. If after all the steps are done and your
unit does not respond to remote signal, hold the temp
High Fan - Press the High Fan button to adjust the fan
speed to high.
and the temp
buttons simultaneously for three
seconds, or until the display window shows "E" to
Fill Piece Installation
PDXRC
Remote
Control
Temperature
Cooler
Warmer
Heat
Power
Cool
Low
Fan
Fan
Only
High
Fan
920-172-00 (2-08)
|