INSTALLATION MANUAL
WS06
GE Switch:
ASR-4173-500
(UL Recognized
IMPORTANT
Component)
Top
Must use this wiring diagram for installation.
Do not use Thermador wiring diagram.
Switch: Red
Low speed
LO
HI
WARNING
OFF
MED
Electrical wiring should be done by a qualified person(s)
Switch: Yellow
in accordance with all applicable codes and standards,
including fire-rated construction. An unqualified person
doing the work could result in fire, electric shock or injury.
Switch: Black
High speed
This switch uses 120 V AC, Max 16 Amp. Do not connect
to other voltage or over current rate since fire, electric
shock or damage could result.
Switch: Blue
Medium speed
Be sure to switch power OFF at service panel before
wiring.
WHITE
/NEUTRAL
BLACK
/120V AC
< CONNECTING POWER SUPPLY WIRES >
1. A 2-1/2" deep Wall Box must be used to allow space for
wire connections between switch and 120 volt Power
Input Leads.
2.
Connect the electrical wires in accordance with
wiring diagram (figure 1).
Connect wires tightly and securely using wire
connectors (not supplied).
3.
Attach the wall plate, and secure with 2 screws.
4. Turn on the electrical circuit to the power unit. Check
the ventilating functions at each speed control
positions. Make sure that the range hood has no
abnormal noises and/or vibration.
From
Blower Moter
< Connection Diagram >
FIG 1
Your installation is now complete.
If you should require service or replacement
parts on your ventilation system.
contact:
Motor Green or
Bare Ground Wire
- Grounded to
Wall Box
2-1/2" Deep Wall Box
(must be grounded)
Fuji Industrial USA,Inc.
16300 Christensen Rd, #212 Seattle, WA 98188
1-888-547-9880
Bowers #52 or Equivalent
FIG 2
READ AND SAVE THESE INSTRUCTIONS.
Keep this manual in a convenient place for future reference.
FUJI INDUSTRIAL CO.,LTD .
030984
|