FMW51BC1
External Battery Charger
User’s Guide
2. Insert the battery pack into one of the slots in the
battery charger as shown in the following figure
until the battery pack is firmly seated in the charger.
PenCentra 130 / Stylistic LT
The FMW51BC1 external battery charger allows
you to charge up to two battery packs
simultaneously.
3. There are two status indicators on the battery
charger, one for each slot. The status indicators
change colors to represent different battery
conditions, as noted in Table 1.
Table 1: Status Indicator States
Caution
Indicator
Condition
Status
UL Notice: FMW51BC1 External Battery Charger
Power
OFF
Green/ON
OFF
AC Adapter not connected
AC Adapter connected
No battery installed
Charge complete
PenCentra 130 Users: Use this battery charger with
the CP021031 (FMW51BP1) battery pack only.
Battery 1/
Battery 2
Stylistic LT Users: Use this battery charger with the
3-cell battery pack CA54200-0502 (FMW29BP2) or
6-cell battery pack CA54200-0506 (FMW29BP1) only.
Green/ON
Amber
ON
Charging
1
Blink
Standby (Waiting to charge)
Battery pack alarm
Battery charger alarm
Using the Battery Charger
0
2
Red
ON
To charge your battery pack(s) in the external
battery charger:
1,2
Blink
1
1. Connect an FPSI DC power source such as AC
adapter FMWAC4A, FMWAC4B, FMWAC4C
or auto adapter FMWCB2 to the DC input on
the battery charger. The Power status indicator
on the charger turns on indicating that power
is supplied to the charger.
Blinks at rate of one second on, one second off.
2
If the battery charger indicates a fault condition with the
battery pack, remove the battery pack, disconnect power to
the charger, and contact your local help desk or your reseller
for further assistance.
Status
Indicators
Slide
Connector Pins
Battery Slot 2
Power
1
Battery 1
Battery Slot 1
2
DC Input
Battery 2
Rechargeable
Battery Pack
Stylistic LT and PenCentra 130 are trademarks of Fujitsu Personal Systems, Inc. © 1999 Fujitsu Personal Systems, Inc.
6/99
58-0664-00A
|