JP328SK
GE® 30" Built-In Electric Cooktop
Dimensions and Installation Information
21-1/4"
30-1/4"
Cooktop
†Note: Check local codes for required breaker size
KW Rating
3
Important: Maintain 5" (12.7 cm) minimum
vertical clearance between the cooktop bottom
and any combustible surfaces.
13" MAX.
depth
7.4
5.6
240V
208V
Clearance not required when installing wall
oven underneath. Requires an 18" minimum
from cooktop to adjacent overhead cabinets.
Units are furnished with a 48" flexible
armored cable.
Breaker Size
19-1/2"
40 Amps†
240V
208V
30" MIN. to
unprotected
cabinet
1-3/4" to
rear wall
30 Amps†
28-1/2"
2"
18" MIN.
to cabinet
clearance to
side wall
Cooktop models JP328WK/328BK/328CK/328SK are approved for use over
GE 27" or 30" Single Wall Ovens. Refer to cooktop and wall oven installation
instructions packed with product for current dimensional data.
from cut-out
2-1/2"
(min.)
If installed with a GE Telescopic Downdraft System, consult both
cooktop and downdraft installation instructions packed with product
before installing. Cooktop gas/electric supply may need to be re-routed
to install downdraft.
5-1/2"
clearance to
side wall
Cut should
not interfere
with cabinet
structure
The countertop must be at least 26" deep with a flat surface area of
23-1/2" or more, front to back. In addition, other clearances to the front
edge of the countertop must be considered.
from cut-out
Electrical junction box 16" MIN.
below countertop
at front
This cooktop cannot be installed in countertops that cannot accept
screws, such as granite or marble, etc.
Filler Trim Kit: When replacing an old GE 30" cooktop (with larger opening)
use the following one-piece trim kit to fill in the over-size hole. Available at
additional cost. JXTR31W (White) JXTR31C (Bisque) JXTR31B (Black)
Installation Information: Before installing, consult
installation instructions packed with product for current
dimensional data.
5" (12.7 cm) Min.
Vertical Clearance
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
Listed by
Underwriters
Laboratories
Specification Revised 4/06
321348
|