GE Clothes Dryer GFDS355GL User Manual

GFDS350GL/GFDS355GL  
GE® 7.5 cu. ft. stainless steel capacity frontload dryer with Steam  
Dimensions and Installation Information (in inches)  
27  
33  
Gas Dryer Rating  
60Hz, 6A  
1-5/8  
120V  
Exhaust Options: 3-way via rear, left, and bottom.  
Circuit Requirements: An individual, properly grounded  
branch circuit, protected by a 15-20 amp circuit breaker  
or a time-delay fuse, is required.  
Note: Dryer wall outlet must be located within 36”  
of service cord entry and accessible when dryer is  
mounted in position.  
40-1/2  
Installation Information: For complete information, see  
installation instructions packed with your dryer.  
3-3/4  
5-1/2  
For answers to your Monogram,® GE Profileor  
GE® appliance questions, visit our website at  
ge.com or call GE Answer Center® service,  
800.626.2000.  
Specification Revised 10/10  
360482  
 
GFDS350GL/GFDS355GL  
GE® 7.5 cu. ft. stainless steel capacity frontload dryer with Steam  
Dryer Exhausting Information – Metal Duct Only  
For complete information, see installation instructions packed with your dryer.  
Best performance  
Maximum length of 4"  
dia. rigid metal duct  
Ducting Materials: For best performance, this dryer should be vented with 4” diameter  
all rigid metal exhaust duct. If rigid metal duct cannot be used, then UL-listed flexible  
metal (semi-rigid) ducting can be used (Kit WX08X10077). In special installations, it may  
be necessary to connect the dryer to the house vent using a flexible metal (foil-type) duct.  
A UL-listed flexible metal (foil-type) duct may be used ONLY in installations where rigid  
metal or flexible metal (semi-rigid) ducting cannot be used AND where a 4” diameter can  
be maintained throughout the entire length of the transition duct. Please see installation  
instruction packed with your dryer for complete instructions when using flexible metal (foil  
type) ducting.  
A
A
Exhaust hood type  
4
B
Number  
of  
A
4"  
B
90°  
Domestic  
dryer models  
2-1/2"  
opening  
2-1/2  
turns  
opening  
0
1
2
3
90 ft.  
60 ft.  
45 ft.  
35 ft.  
60 ft.  
45 ft.  
35 ft.  
25 ft.  
Exhaust Length Calculation:  
7.0, 6.0 and 5.8 cu. ft.  
capacity models  
all gas dryers  
1. Determine the number of 90° turns needed for your installation. If you exhaust to the  
side or bottom of dryer, add one turn.  
2. The maximum length of 4’ rigid (aluminum or galvanized) duct which can be tolerated is  
shown in the table.  
A turn of 45° or less may be ignored. Two 45° turns within the duct length should be  
treated as a 90° elbow.  
A turn over 45° should be treated as a 90° elbow.  
Dryers must be exhausted to the outside.  
Caution: For personal safety do not terminate exhaust into a chimney, under any enclosed  
house floor (crawl space), or into an attic, since the accumulated lint could create a fire  
hazard or moisture could cause damage. Never terminate the exhaust into a common duct  
or plenum with a kitchen exhaust, since the combination of lint and grease could create a  
fire hazard.  
Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird  
nesting, etc. The wall cap must also be located at least 12" above the ground or any other  
obstruction with the opening pointed down.  
For more information on venting kits and accessories, please call 1-800-GE-CARES.  
Specification Revised 10/10  
360482  
 
GFDS350GL/GFDS355GL  
GE® 7.5 cu. ft. stainless steel capacity frontload dryer with Steam  
Features and Benefits  
• Steam Refresh/Steam Dewrinkle - Steam Refresh helps reduce wrinkles, odors and  
rejuventates fabrics, while Steam Dewrinkle reduces wrinkles and freshens clean  
clothes  
• Sensor Dry Plus™ - Innovative moisture-sensing technology helps maintain quality  
• eDry option - Energy-saving option reduces dry temperatures on select cycles  
without sacrificing performance  
• Active Wear cycle - Specific settings to take special care of clothing worn for active  
sports exercise  
• My Cycles - Custom cycle that can be set for specific or frequent needs  
• Speed Dry - Quickly dries items and small loads for families on the go  
• 1- 24-hour Delay Start - Set the dryer to begin cycles whenever it’s convenient for you  
• Up to 90 ft. venting capability - Has long equivalent ducting performance for more  
flexible installation  
• Up to 90 ft. venting capability - Has long equivalent ducting performance for more  
flexible installation  
• Model GFDS355GLMS – Metallic silver  
• Model GFDS350GLWW – White on white  
• Model GFDS355GLMV – Vermillion Red  
Specification Revised 10/10  
360482  
 

EdgeStar Air Conditioner AP12005ECO User Manual
Excalibur electronic Handheld Game System 404 2 User Manual
Fisher Price Baby Toy B9774 User Manual
Focal Car Speaker 25 A1 User Manual
Frigidaire Air Conditioner 309000848 User Manual
Frigidaire Convection Oven FPGF3081K F User Manual
Frigidaire Range 316135921 User Manual
Furuno SONAR CH 34 36 User Manual
GE Clothes Dryer JBP26 User Manual
Genius Clock Radio GEO 1 User Manual