SCB1001MSS
GE Profile Advantium® 120 Wall Oven
4-3/16
Cabinet width
Advantium wall oven/GE Profile cooking tower dimensions and cabinet installation information (in inches)
4-3/16
Note: Cabinets
installed adjacent
to wall ovens must
have an adhesion
spec of at least a
194°F temperature
rating.
Cutout width
Junction box location
X
A
A
B
B
H
Z
D
2-1/2" MIN between cutouts
recommended—2" MIN required
Cutout depth
Excluding
Handle
D
W
Junction
box
Note: 2" minimum
between cutouts
when installed
above warming
drawer or single
wall oven.
location
A
B
Construct Solid Bottom
Conduit
(46" long)
MIN 3/8" Plywood Supported by
2 x 4 or 1 x 2 Runners, all Four Sides.
(Must Support 150 lbs. for Advantium)
(Must Support 200 lbs. for Wall Oven)
Conduit
(48-1/2"
long)
Y
H
Cutout height
Construct Solid
Bottom Min.
3/8" Plywood
Supported by
2 x 4 or 1 x 2
Runners, all
Four Sides.
(Must Support
150 lbs.)
9-1/4" cutout height
28-1/2" cutout width
Required
cutout location
36-3/4"
minimum
from floor
Installation
Information:
Before installing,
consult installation
instructions packed
with product for current
dimensional data.
W
2" MIN between cutouts
1" Min. above toekick or adjust
to oven installation height
Cabinet width
A=Allow 1” overlap of oven over top and bottom edges of cutout.
B=Allow 11/16”-3/4” for overlap of oven over side edges of cutout.
A=Allow 1” overlap of oven over top and bottom edges of cutout.
B=Allow 11/16”-3/4” for overlap of oven over side edges of cutout.
C
L
2 x 4’s or
equivalent
solid floor
Cabinet
Width
W
Width
H
D
X
Y
Z
Height
Depth
Cutout
Width
Cutout
Height
Cutout
Depth
(excluding
handle)
minimum
SCB1000/1:27" Installation
without trim kit
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
27
30
26-3/4 19-1/32 21-1/2
29-3/4 19-1/32 21-1/2
25-1/8
25-1/8
17-1/2
17-1/2
23-1/2
23-1/2
SCB1000/1:30" Installation
with trim kit
Suitable
bracing
to support
runners
21-5/8"
over centerline
of cabinet
Listed by
Underwriters
Laboratories
(Must Support 275 LBS.)
Specification Created 9/06
240405
|