GL-1200S Standard Surface
Water-Proof Electromagnetic Lock
Regular Installation
Magnet
Armature
(On Power)
Fire Exposure and Hose Stream Tests were conducted in
accordance with the standard, "Positive Pressure Fire Tests of
Door Assemblies," ANSI / UL 10B and 10C, uniform building
code standard UBC 7-2 (1997).
Unique Anti-Residual design
When the power is switched off, the holding force will be
discontinuity and the bolt was installed in armature will pop
Statement
The fail-safe Electromagnetic Lock design with no
mechanical parts but magnetic force to secure and release the
doors, suitable for use in areas which required access
controlled or egress such as exit door.
The Electromagnetic Locks are totally sealed in an epoxy
filled stainless steel case for water-resistant and vandal-
resistant purpose. A threaded conduit fitting ensures weather
resistant protection of the wiring therefore it is ideal for indoor
and outdoor applications, even in severe weather.
We offers up to 1200 pounds holding force with 12V DC
power input (24V DC or 12/24V DC dual input voltage
available by special order), and it can be applied with access
control, and with the full range of optional brackets, it can be
installed on all type of door frames such as Hollow and
Wooden door. It is the best choice for electronic security
industry and system integrators.
This series of Waterproof Magnetic Lock is made with epoxy
potting compound and is protected by this compound. Also,
GEM Waterproof Series Magnetic Locks have been proved to
Specifications
have withstood
a
water resistance as established in
Voltage Tolerance: 15%
accordance with the test procedures of IPX7, IPX8 through a
trusted third party. Therefore users need not worry that the
lock will be rusted or sparked, if the lock is using in outdoor
applications and installing in confined space where any
inflammable gas.
Current Draw: 460mA@12Vdc (at temperature 20 C)
(Further notice for diverse input voltage on special order requirement)
Operating Temperature: -10~55C (14~131F(
Humidity: 0~95% non-condensing.
Lock's surface Temperature (when the power is on):
)current temperature +20C (
Holding Force: 1200 lbs )545 Kg(
Dimensions:
Magnet:(L) 220, (W) 68, (D) 41 mm
Armature Plate:(L) 185, (W) 62, (D) 16 mm
Special Finishes for magnet and armature plate: Zinc
Epoxy Potting Compound: E87252 (S), UL94V-0
Weight )Approx.(: 5.0 Kg
Warranty
Magnetic bond sensor monitor output (GL-1200S-R)
(SPDT rated 0.25A@12V DC), remotely monitors the door
lock or unlock status. (N.C. Output--Door opened; N.O.
Output--Door closed)
The product is warranted against defects in material and
workmanship while used in normal service for a period of
year from the date of sale to the original customer. The GEM
policy is one of continual development and improvement;
therefore GEM reserves the right to change specifications
without notice.
5
GIANNI INDUSTRIES, INC.
No. 13, Zhong Sing Road, Tu-Cheng Industrial Zone,
Tu-Cheng City, Taipei, Taiwan 23678
The products are manufactured under an ISO
9001
&
QC 080000 Certified Quality
Management Program environment back its
product quality, performance and commitment
to customer satisfaction.
Tel: 886-2 2267 7986 / Fax: 886-2 2267 9876
E-Mail: [email protected]
Website: gianni.tw
Copyright 2008 Gianni industries, inc. All rights reserved.
DM-CA-GL-1200S Ver. C Published on 2008.05.12
|