MODEL H2882
71⁄2" PNEUMATIC DRUM
SANDER
INSTRUCTION SHEET
EYE/EAR INJURY HAZARD!
Wear safety glasses and
hearing protection during
use of this tool!
OVER INFLATION HAZARD!
Never exceed 8 PSI!
RESPIRATORY HAZARD!
Sanding produces fine
dust. Wear the appropriate
protection during use!
Figure 1. Model H2882.
Introduction
This rolling-pin style pneumatic drum sander is
perfect for hand contouring and smoothing proj-
ects that are too large to use with a stationary
3
sander. Simply chuck the ⁄8" spindle into a por-
table electric drill, cordless drill or air powered drill
for two-handed control. Choose this 71⁄2" x 21⁄4
"
diameter size for getting into tight areas. Features
ball bearing handle and air valve for easy bicycle
pump inflation.
Figure 2. Model H2882 in action.
71⁄2" Aluminum Oxide Sanding Sleeves
Inventory
A. Drum Sander.............................................. 1
B. Spare Valve Cap........................................ 1
H3881 21⁄4" x 71⁄2" x 60 Grit
H3882 21⁄4" x 71⁄2" x 100 Grit
H3883 21⁄4" x 71⁄2" x 150 Grit
H3884 21⁄4" x 71⁄2" x 180 Grit
H3885 21⁄4" x 71⁄2" x 220 Grit
H3886 21⁄4" x 71⁄2" x 320 Grit
Operation
Slide the sanding sleeve over the drum. Remove
the plastic cap on the handle with a small screw
driver to expose the air valve. Inflate to the desired
pressure. DO NOT exceed 8 PSI!
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
COPYRIGHT © MARCH, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#PC8029 PRINTED IN TAIWAN
|