SPOTLIGHT
3 Million Candle Power with 9” Lens
OPERATING INSTRUCTIONS
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
©
®
Copyright 2003 by Harbor FreightTools . All rights reserved. No portion of this manual
or any artwork contained herein may be reproduced in any shape or form without the
express written consent of Harbor Freight Tools.
For technical questions, please call 1-800-444-3353
9.
AVOID TOUCHING THE LENS as it may become hot during operation.
10.
DO NOT DISASSEMBLE THE BATTERY or remove any parts from the Battery
and surrounding connections.
11.
DO NOT ALLOW THE SPOTLIGHT TO BE EXPOSED TO FIRE OR HIGH HEAT
as this may result in an explosion.
12.
13.
DISCONNECT POWER. Unplug charger when not in use.
MAINTENANCE. For your safety, maintenance should be performed regularly by a
qualified technician.
14.
SPOTLIGHT IS NOT COMPLETELY WATERPROOF.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be
understood by the operator that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
Warning: Operation of equipment in close proximity to a heart pacemaker could cause
interference or failure of the pacemaker.
Warning: This product contains or, when used, produces a chemical known to the State
of California to cause cancer and birth defects or other reproductive harm.
(California Health & Safety Code § 25249.5, et seq.)
Note: Performance of this tool (if powered by line voltage) may vary depending on varia-
tions in local line voltage. Extension cord usage may also affect tool performance.
PROPER VOLTAGE WARNINGS
Common household current is 110-120 volts. As long as the outlet used with the tool
is rated from 110-120V there will be no complications using it with household receptacles.
Plug the tools with Power Adapter into a 110-120V properly grounded outlet protected by a
15-amp, dual element time delay fuse or circuit breaker.
NEVER try to plug a 110-120V tool into a 220-240V circuit or serious complications
and possible injury to the operator may occur. The plugs have different shapes to prevent
this.
UNPACKING
When unpacking your Spotlight, check to make sure the following parts are included. If
any parts are missing or broken, please call Harbor FreightTools at 1-800-444-3353.
SKU 08825
For technical questions, please call 1-800-444-3353.
PAGE 3
CHARGING INSTRUCTIONS
Actual charging of the Spotlight Battery is required before using the Spotlight.
To recharge the Battery follow the directions below.
1. To charge the Battery (3), your Spotlight comes with an AC/DC Adapter (19). Lift the Waterproof
Stopper (7) on top of Spotlight. Insert the round end of the AC/DC Adapter (19) into the AC/DC
Socket (13). Plug the prong end of the AC/DC Adapter (19) into an electrical outlet. The red
charging light will turn on while the battery is being recharged. See Figure A, B.
2. Charging time will take from 10 to approximately 12 hours.The red light will shut off automatically
when the battery is fully charged. After the battery is charged for the required time, unplug the
AC/DC Adapter from the wall socket and the AC/DC Socket on the Spotlight. Never attempt to
turn on the Spotlight while it is being recharged. Once recharged, with the AC/DC Adapter
removed, the Spotlight is ready to be used. A fully charged Spotlight will provide approximately
a 20 minute strong beam or 50 minute weaker beam.
Note: After each use of the spotlight,
Note:This unit is equipped with an automatic shutoff. If the
always fully recharge the battery.
Battery’s power is running low, the unit will automati-
cally stop operating to protect the battery. Charge the
battery immediately.
7, 13
6, 14
5
19
21
20
Figure C
Figure A
Figure B
19
CAR ADAPTER
1. Your Spotlight comes with a Car Adapter (20, 21). To operate your Car Adapter, remove the
Rubber Cover (5) and insert the narrow end of the Car Adapter (21) into the 12 V Inlet (17)
underneath. Figure A. The other end (20) will fit into your car’s cigarette lighter socket. See
Figure C.
2. The Spotlight is ready to be used while plugged into the Car Adapter. The Car Adapter will not
charge the Spotlight’s battery, however. While using the Car Adapter, take care so that the
car’s battery does not get discharged.
OPERATION
To assist you with operating your Spotlight, please refer to the Operational Figures as well as
the Parts List and Assembly Diagram.
1. Push forward on the 3-Way
Slider Switch (6) to one of the
two ON positions to turn the
Spotlight ON. Pull the 3-Way
Slider Switch all the way back
22b
to turn the Spotlight OFF - see
Switch, right.
Switch
22a
2. Adjust the Stands (22a & 22b) to angle the beam of light to
the desired position. Figure D.
Figure D
REV 06/03; 09/03; 08/04; 10/04; 01/07
SKU 08825
For technical questions, please call 1-800-444-3353.
PAGE 4
REPLACING BATTERY
Remove Rear Cover (2). Remove pin/connectors from the old Battery. Reconnect Red and
Black pins/connectors to the proper corresponding connectors on the new battery. After connecting
properly, put the new Battery back in Housing. Replace Rear Cover (2).
Caution: Burns or an explosion could occur if handled improperly. (See Battery Disposal).
See Figure E.
Glass
Lens (11)
Batteries (3)
Reflector
Battery
Connecting
Wire (1)
Glass (10)
4
Bulb (18)
Battery
Lamp Lid (12)
Cover (2)
Figure E
Figure F
See Parts Drawing on Page 6.
IF THERE IS ANY QUESTION ABOUT A CONDITION BEING SAFE OR UNSAFE, DO NOT OPERATE THE TOOL.
WARNING–BATTERY DISPOSAL
The Spotlight is powered by a Battery which will have a long life span. When the
Battery is no longer functioning, the used up Battery should be properly recycled.
Many states require recycling. Contact your local solid waste authority for information
on recycling.
Battery Lifetime
Note: Always recharge the Spotlight within a 24 hour period after each use.
Caution: Never completely discharge the battery. Deep battery discharge will decrease
battery life.
The battery capacity will be reduced if the Spotlight is not used for 3 months. It is recommended
that the battery be recharged at least one time every 3 months.
Note: The battery should be charged before the first use.
MAINTENANCE
1. For better and safer performance, keep all parts of this product clean and dry.
2. Periodically check to see that all hardware is in place.
REV 09/03; REV 10/04; 01/07
SKU 08825
For technical questions, please call 1-800-444-3353.
PAGE 5
PARTS LIST
PART
DESCRIPTION
QTY
Battery ConnectingWire
Rear Cover
1
1
2
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
2
Battery
3
Plastic Body Housing
Rubber Cover
3-Way Slider Switch Cover
Waterproof Stopper over Adapter Socket
Iron Ring
Sealing Ring
Reflector Glass
Glass Lens
Lamp Lid
Socket (Power Adapter)
Switch
Circuit Board
Charging Light
12V Inlet
Bulb
AC/DC Adapter
Car Adapter
Adjustable Stand (front) (not shown)
Adjustable Stand (back) (not shown)
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20/21
22a
22b
PARTS DRAWING
NOTE: Some parts are listed and shown for illustration purposes only and are not available individu-
ally as replacement parts.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDEDTHE PARTS DIAGRAM INTHIS MANUAL
AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY
REPRESENTATION OR WARRANTY OF ANY KINDTO THE BUYER THAT HE OR SHE IS QUALIFIED TO
MAKE ANY REPAIRSTOTHE PRODUCT ORTHAT HE OR SHE IS QUALIFIEDTO REPLACE ANY PARTS
OFTHE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATESTHAT
ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED
TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING
OUT OF HIS OR HER REPAIRSTOTHE ORIGINAL PRODUCT OR REPLACEMENT PARTSTHERETO, OR
ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTSTHERETO.
REV 09/03; 08/04; 01/07
SKU 08825
For technical questions, please call 1-800-444-3353.
PAGE 6
|