9’ UMBRELLA
w/Aluminum Pole
93660
Materials:
100% polyester, antique beige
colored fabric. UV treated, mil-
dew resistant with eight ribs, 9
ft. long, and an aluminum pole
with a tilt mechanism that will
angle at a 45 degree angle, left
or right.
3491 Mission Oaks Blvd., Camarillo, CA 93011
®.
Copyright © 2005 by Harbor Freight Tools
All rights reserved. No portion of this manual or any artwork contained herein
may be reproduced in any shape or form without the express written consent of Harbor Freight Tools.
UNPACKING
When unpacking, check to make sure all parts shown on the back of this instruction sheet are included. If any parts are missing or
broken, please call Harbor Freight Tools at the number shown on the front of this sheet as soon as possible.
ASSEMBLY AND OPERATING INSTRUCTIONS
NOTE: All parts below refer to the parts listed on the reverse side of this instruction sheet.
1. Caution: DO NOT attempt to use this Umbrella in moderate or high wind conditions. Doing so may cause personal injury
and/or damage to the Umbrella and personal property. Be careful not to pinch fingers when opening and closing the Umbrella.
2. To assemble, insert Lower Pole (8) with its threaded end upward, securely into a heavy duty umbrella stand.
NOTE: This Umbrella is intended for use only with a heavy duty umbrella stand which is not provided with this product.
Adjustable, heavy duty umbrella stands are sold separately by special order from Harbor Freight Tools (SKU 94041).
3. Screw the Connector/Crank (7) onto the threaded end of the Lower Pole.
4. Screw the Upper Pole (6), with its pre-attached upper umbrella assembly, securely into the top of the Connector/Crank.
5. Hand crank the Connector/Crank clockwise in order to raise the Hub/Runner (5)
above the self-locking Safety Lock (10), thereby locking the upper umbrella
assembly into place. The Umbrella is now ready for use.
Hub/Runner (5)
6. If you wish to tilt the upper part of the umbrella for shade, press the “push
Push Button (9)
button”. It will tilt to a 45 degree angle. To straighten up, reverse the tilt until the
tilt mechanism “clicks” into place for safety. Note: When tilting, opening, or
closing the umbrella, watch your head for injuries. See Figure 1.
7. When finished using the Umbrella, crank the Connector/Crank counterclockwise
until the upper umbrella assembly is completely closed.
Figure 1
CLEANING AND MAINTENANCE
1. To clean, fully open the Umbrella. Wipe with a clean, damp cloth, using a mild soap with water if necessary.
2. Periodically, lightly lubricate all moving parts.
SEE REVERSE SIDE OF THIS INSTRUCTION SHEET FOR PRODUCT WARNINGS,
PRECAUTIONS, PARTS LIST, AND ASSEMBLY DIAGRAM.
|