HEAVY DUTY
TACKING GUN
(Model 93926)
ASSEMBLY AND OPERATING INSTRUCTIONS
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Due to continuing improvements, actual product
may differ slightly from the product described herein.
Copyright© 2006 by Harbor FreightTools®.
All rights reserved. No portion of this instruction sheet or any artwork contained
herein may be reproduced in any shape or form without the express written consent of
Harbor FreightTools.
TO PREVENT SERIOUS INJURY,
READ AND UNDERSTAND ALL WARNINGS
AND INSTRUCTIONS BEFORE USE.
For technical questions, please call 1-800-444-3353.
PRODUCT SPECIFICATIONS
Item
Description
Staple Size Capacity
Magazine Type
Magazine Capacity
Trigger Actuation Type
Overall Dimensions
Net Weight
Accepts From 5/32” to 9/16” Long x 7/16” Wide x 3/64” Thick (18 Gauge) Staples
Spring Loaded, Slide-Strip Magazine
Accepts Up To 80 Staples
Palm-Push Trigger Lever
7-1/4” Long x 1-1/2” Wide x 6-7/8” High
1.9 Lbs.
SAVE THIS INSTRUCTION SHEET
You will need this instruction sheet for the safety warnings and precautions, assembly, operating, inspection, maintenance and
cleaning procedures, parts list and assembly diagram. Keep your invoice with this instruction sheet. Write the invoice number on the
front cover. Keep this instruction sheet and invoice in a safe and dry place for future reference.
UNPACKING
When unpacking, check to make sure that the product is intact and undamaged. If any parts are missing or broken, please call Harbor
Freight Tools at the number shown on the front of this instruction sheet as soon as possible.
SAFETY WARNINGS AND PRECAUTIONS
1.
2.
3.
Keep work area clean. Cluttered areas invite injuries.
Keep children away. Children must never be allowed in the work area. Do not let them handle this product.
Store idle equipment. When not in use, tools must be stored in a dry location to inhibit rust. Always lock up tools and
keep out of reach of children.
4.
Use the right tool for the job. Do not attempt to force a small tool or attachment to do the work of a larger industrial tool.
There are certain applications for which this tool was designed. It will do the job better and more safely at the rate for which
it was intended. Do not modify this tool, and do not use this tool for a purpose for which it was not intended.
Use eye protection. Always wear ANSI approved impact safety eye glasses under an ANSI approved full face shield.
Point the Tacking Gun away from yourself and others at all times and especially when opening the Magazine to
clear a jammed staple. As the Magazine is opened, the jammed staple may be shot out unexpectedly.
Place the staple exit point firmly against the work surface before firing. Staples fired “into the air” can cause serious
injury.
5.
6.
7.
8.
Use the proper size staple. This product accepts from 5/32” to 9/16” long x 7/16” wide x 3/64” (18 Ga.) staples only.
|