FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy, and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Consult the dealer or an experienced radio/TV technician for help.
Not suitable for children under 3 years
because of small parts - choking hazard.
Product and colors may vary.
© Disney/Pixar
®* and/or TM* & © 2006 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
03934
P/N 6604030000
Playtime
• Press large chest button to make Buzz Lightyear’s wings expand.
• Press wings back and flip down to reset.
• Push red, green, or blue button for phrases!
• Press button on arm for blinking lights and laser sounds!
Press for
Speech
Press to
extend wings
Press for
laser lights
and sounds
Wing Attachment
• As an added feature, Electronic Battle Buzz Lightyear’s wings
are designed to come off under undue pressure. If this happens, simply
re-attach wings as shown.
Snap into place
Troubleshooting tip
• Replace batteries if speech becomes slow.
To Replace Batteries
Use a Phillips/cross head screwdriver
(not included) to loosen screw in battery
compartment door (screw remains
attached to door). Remove door and
discard old batteries. Insert 3 x 1.5V
fresh “AA” or R6 size batteries. Alkaline
batteries recommended. Replace door
and tighten screw.
CAUTION:
1. Be sure to insert the batteries correctly and always
follow the toy and battery manufacturers’ instructions;
2. Do not mix old and new batteries or alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium)
batteries;
3. Always remove weak or dead batteries from the
product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries
specified and be sure to insert item correctly by matching the +
and – polarity markings.
2. Do not mix old and new batteries or standard (carbon-zinc) with
alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long
time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical
interference, move it away from other electrical equipment. Reset
(switching off and back on again or removing and re-inserting
batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other
types of batteries. Always remove from the product before
recharging. Recharge batteries under adult supervision. DO NOT
RECHARGE OTHER TYPES OF BATTERIES.
|