™
RVM1335WC—Hotpoint 1.3 Cu. Ft. Counter Saver Plus Microwave Oven
Dimensions (in inches)
Optional Accessories (Available at additional cost)
JX81A–Recirculating
Charcoal Filter Kit
30"
MIN.
66" MIN.
Mounting
height
from
12” Filler Panel Kits
width
JX41–Black Filler Panel Kit
To be used when the
Counter Saver Plus™
microwave oven cannot
be vented to the outside.
Exhaust outlet
connects to
3-1/4" X 10" duct
required
JX40WH– White Filler Panel Kit
floor
12"
MAX.
When replacing a 36" or 42"
range hood, this kit fills in the
additional width to provide a
custom, built-in appearance. For
installation between cabinets only;
not for end-of-cabinet installation.
Each kit contains two, 3"-wide filler
panels. Two kits are needed for a
42" opening.
14"
16-1/2"
21-3/4"
15-7/8"
Door open
Ventilation Options: The Counter Saver Plus™ microwave oven is designed for adaptation
for the following three types o ventilation:
Outside Exhaust (Vertical–as shown above)
Outside Exhaust (Horizontal)
Recirculating Exhaust (Non-vented ductless–see Filter Kit Drawing)
™
Important Information: When installing the Counter Saver Plus
microwave oven over a range, allow minimum of 2" from bottom of
™
Counter Saver Plus microwave oven to top of range backguard to allow
for removal of light covers.
Installation Information: This information is not intended to be used for
installing unit described. Before installing, consult installation instructions
packed with product/kit for current dimensional data.
Note: Before Installing, comsult installation instructions for curent dimensional data on
these therr types of ventilation
Listed by
Underwriters
Laboratories
R
Specification Revised 6/00
|