MODEL H0588
4" ANGLE DIE GRINDER
INSTRUCTION SHEET
1
⁄
EYE INJURY HAZARD!
Always wear safety glasses
when using this tool to
prevent serious personal
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected
operation during service.
EXPLOSION HAZARD!
Never exceed 120 PSI.
Figure 1. Model H0588.
Introduction
Angle Die Grinders are excellent for reaching
Quick
Connector
Quick
Connector
Lubricator
Regulator
sideways into areas that are relatively confined.
Your
Tool
Air
Compressor
No-load speed is 18,000 RPM and collet size is
1
Quick
Coupler
⁄
4". Requires 90 PSI with 4 CFM of compressor
1
Quick
Coupler
capacity. Air inlet is ⁄4" and air exhaust is in the
rear. Weighs just over 1 lb.
Air Hose
Filter
Figure 2. Installing your tool.
Inventory
A. Die Grinder................................................. 1
B. Flat Wrench 17mm..................................... 1
C. Flat Wrench 12mm..................................... 1
Operation
Tool requires 90 PSI to operate correctly.
To improve tool lifespan, use a filter/lubricator/
regulator as shown in Figure 2. Otherwise, lubri-
cate daily with a couple drops of pneumatic tool oil
directly into the air fitting as shown in Figure 3.
Figure 3. Lubricating directly into air fitting.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
COPYRIGHT © FEBRUARY, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#KM7957 PRINTED IN TAIWAN
|