Grizzly Automobile Parts H3258 User Manual

Model H3258  
Air Filter/ Regulator/ Lube  
with Gauge  
When installed in an air system, the Model H3258  
removes micro-particles and moisture droplets, lubri-  
cates your air tools, and regulates air flow.  
5. Connect the air line (A) to the line-IN 14"NPT  
threads (B) on the Model H3258 as shown in  
Figure 2. Note—Use as short of an air line  
as possible, with minimal bends, to maintain  
an accurate working pressure.  
INSTALLING REGULATOR  
6. Thread on a male connector (D) to the Line  
“OUT” threads (C) followed by a quick cou-  
pler (E) as shown in Figure 2.  
To install the Model H3258 to your pneumatic  
device:  
INSTALL THIS SYSTEM AS CLOSE TO THE AIR  
TOOL AS POSSIBLE FOR BEST PERFORMANCE!  
1. Disconnect the compressor system from the  
power source!  
To Air Tool  
From Compressor  
2. Drain the air pressure out of the tank and lines  
before connecting the Model H3258 to your air  
line.  
Air Hose  
Air Hose  
3. Mount the Model H3258 (in the upright position  
shown in Figure 1) on a wall close to the area of  
air tool operation, using the wall mount guide  
holes. You can also connect it directly onto the  
compressor shut off valve. Note—Place the  
Model H3258 away from direct sun or hazardous  
materials.  
C
D
A
B
E
F
G
Figure 2. Connection diagram.  
7. The quick coupler will accept a hose  
connector (F) that attaches to the air hose  
(G) going to your tool.  
Oil Fill Cap  
Screw  
Control  
Knob  
8. Fill the oil cup to the designated fill level with  
Pressure  
Gauge  
air tool oil.  
Wall  
Mounts  
9. When the set up is complete and the fittings  
are secure, start your air compressor and let  
the air pressure build to the operating level.  
Drain  
Valve  
10. Check for air leaks along the line by using  
soapy water. If there are leaks present, dis-  
connect the line on both sides of the leak.  
Reseal the leaking fittings with teflon tape  
and reconnect the line.  
Figure 1. Identification and mounting orientation.  
4. Connect a 14" NPT air line (A), in Figure 2, to the  
shut-off valve on your air compressor. Seal all  
the fittings with teflon tape to prevent leaks and  
product failure.  
If you need additional help with this procedure,  
call our service department at: (570) 546-9663.  
 

Gyration Mouse Ultra Cordless Optical Mouse User Manual
Hamilton Beach Oven 840073000 User Manual
Hans Grohe Plumbing Product 06094000 User Manual
Heat Glo LifeStyle Cooktop VRTIKL AU User Manual
Honeywell Thermostat 7300 User Manual
Hotpoint Clothes Dryer TCL770 User Manual
HP Hewlett Packard Personal Computer vl410 User Manual
HP Hewlett Packard Photo Printer 9600 Series User Manual
HP Hewlett Packard Recording Equipment 3438A User Manual
Ikelite Digital Camera SD870 IS User Manual